Filtering by IP-address on the router netis

Настройка роутера Netis

On the page, you can prevent or allow the connection on the IP-address listed devices, and to establish rules for the connection to the router netis.

 

By default, all devices are allowed to connect to the router netis.

Select the tab «Access Control» – sub-tab «IP Filtering» on the left side.

Filtering by IP-address on the router netis WF2419.

On the page, you can prevent or allow the connection on the IP-address listed devices, and to establish rules for the connection to the router netis WF2419.

Select the tab «Access Control» – sub-tab «IP Filtering» on the left side.

Filtering by IP-address on the router netis WF2501

On the page, you can prevent or allow the connection on the IP-address listed devices, and to establish rules for the connection to the router netis WF2501.

  • IP Filtering (IP Address Filtering).
    • StatusDisable or Enable filtering function IP-addresses. The default is off.
    • Filtering RuleSelect the rule: Deny the network access for the devices (IP Address) not listed below (Deny through the router for IP address listed, others are permitted) or Permit the network access for the devices (IP Address) not listed below (Permit through the router for IP address listed, others are denied).
      Click Save, to save the changes in the settings.
  • IP Filtering Rule Settings (IP Filtering List Management).
    • Description – A brief description of the rule.
    • Rule – Select an access rule Deny or Permit.
    • Source HostAll the host – to apply the rule to all sources. Specific host – applies to one source, enter the IP-address of the source that you want to monitor. Host’s subnet – is applied to the host subnet registers the IP-network address and subnet mask. Host’s segment – is applied to the range of the network, where the prescribed initial IP-address and End IP-address.
    • Destination HostAll the host – to apply the rule to all recipients. Specific host – applied to the same destination, enter the IP-address of the recipient. Host’s subnet – is applied to the node subnet registers the IP-network address and subnet mask. Host’s segment –  is applied to the range of the network, where the prescribed initial IP-address and End IP-address.
    • Protocol – Select the protocol to which the rule will be applied: All; TCP (Transmission Control Protocol, Transmission Control Protocol) – one of the basic Internet data transfer protocol for controlling data transmission in networks and TCP / IP subnets; UDP – User Datagram Protocol, responding to small requests from a huge number of clients, such as DNS and streaming multimedia applications such as IPTV, Voice over IP, IP tunneling protocols, and many online games; ICMP -Protocol gateway control messages ICMP are mainly used to transfer error messages and other exceptional situations that have arisen in data transmission, for example, the requested service is not available, or the host or router is not responding. Also ICMP entrusted some service functions. .
    • Port – Specify the port connected to the router.
    • Day (Days To Block) – Select the day of the on rules.
    • Time (Times To Block) – choose the time of inclusion rules.
      Click the Add button, to add the rule.
  • IP Filtering List.
    • The list shows the filter rules for IP-address.
      Click the Modify button or Delete, to modify or remove the filter rule.
      Click Delete All, to delete all the rules.
Вы можете оставить комментарий, или ссылку на Ваш сайт.

Оставить комментарий

Вы должны быть авторизованы, чтобы разместить комментарий.