Local management on the router Tp-link

настройка роутера tp-link

On this page you will be able to prohibit the LAN computers to access the router Tp-link.

 

The default is all computers on the network are allowed to access the web utility device settings. If you want to allow access to the web configuration utility is only for computers on the local network with certain the MAC-addresses, select only the specified computers allowed access to the web configuration utility as an administrator, then select the individual fields of the MAC-addresses.

Select the tab «Security» – sub-tab «Local Management» on the left side.

Local management on the router Tp-link

On this page you will be able to prohibit the LAN computers to access the router Tp-link.

MAC-address must be in the format XX-XX-XX-XX-XX-XX (where “X” – is a hexadecimal number). In this case, only those computers will have access to the web configuration utility with administrative rights, and the other computers will not have access to it.

After clicking the Add button PC MAC-address will be added to the above list of controls.

Click Save, to save the changes in the settings.

If your computer does not have access to the router, and you want to get it again, with a small pin and press for about 10 seconds, hold the Reset button located on the rear panel. The router will reboot and return to the factory settings, web-based utility.

Вы можете оставить комментарий, или ссылку на Ваш сайт.

Оставить комментарий

Вы должны быть авторизованы, чтобы разместить комментарий.